BRZQG - PALGARD EPOXY COATING BLACK
- MSDS: BRZQG
- Manufacturer: PRATT AND LAMBERT
- Product Name: PALGARD EPOXY COATING BLACK
- National Stock Number: 8010-00N043697
Product Identification
Product ID:PALGARD EPOXY COATING BLACK
MSDS Date:07/23/1991
FSC:8010
NIIN:00N043697
MSDS Number: BRZQG
Responsible Party
US
Emergency Phone: 716-873-8000; 800-255-3924
Info Phone: 716-873-8000
Cage: 61196
Contractor
Telephone: 216-566-2902
Cage: 61196
Ingredients
APPROP PROT FACTOR. REFER TO OSHA 29CFR1910.134
RTECS: 9999999ZZ
INDUSTRIAL HYGIENE ASSOCIATION".
RTECS: 9999999ZZ
SECTION BELOW LOWEST EXPOS LIMIT STATED. REMOVE DECOMP
RTECS: 9999999ZZ
BRAZING OBJECTS COATED W/THIS PROD. REFER TO
RTECS: 9999999ZZ
RPTD EXCESSIVE
RTECS: 9999999ZZ
KIDNEY DAM. RPTS HAVE ASSOC PRLNGD/RPTD OCCUP
RTECS: 9999999ZZ
MISUSE BY DELIBERATELY CONCENTRATING & INHALING THE
RTECS: 9999999ZZ
IMMED FLUSH CONTAMD AREAS W/LGE AMTS OF
RTECS: 9999999ZZ
ETHYLENE GLYCOL MONOBUTYL ETHER IS
RTECS: 9999999ZZ
THIS SUBSTANCE IS EXCRETED IN URINE. EXCESSIVE EXPOS
RTECS: 9999999ZZ
RETICULOCYTOSIS, GRANULOCYTOSIS, LEUKOCYTOSIS,
RTECS: 9999999ZZ
MATL (E.G. SAND/EARTH). TRANSFER LIQS TO COVERED
RTECS: 9999999ZZ
INERT ABSORB. USE ONLY NON-SPARKING TOOLS. PLACE
RTECS: 9999999ZZ
PREVENT CONTAMINATION OF SEWERS, STREAMS &
RTECS: 9999999ZZ
DISCARDED DIRECTLY WOULD BE CLASSIFED A HAZ
RTECS: 9999999ZZ
OF RESTRICTED VENT, A NIOSH/MSHA APPRVD ORG VAP
RTECS: 9999999ZZ
SPRAYING, A MECH PREFILTER MAY ALSO BE REQD. IN
RTECS: 9999999ZZ
AIR SUPPLIED RESP MAY BE REQD. IF TLV/PEL ARE
RTECS: 9999999ZZ
PLYAMIDE RESIN
CAS: 68410-23-1
Fraction By Weight: 30%
OSHA PEL N/K
ACGIH TLV: N/K
1%.
CAS: 111-76-2
RTECS: KJ8575000
Fraction By Weight: 15%
OSHA PEL S, 50 PPM
ACGIH TLV: S, 25 PPM; 9293
7%
CAS: 64742-88-7
Fraction By Weight: 15%
OSHA PEL N/K
ACGIH TLV: N/K
SOLVENT NAPHTHA (PETROLEUM), LIGHT AROMATIC; (SOLVENT
CAS: 64742-95-6
RTECS: WF3400000
Fraction By Weight: <5%
OSHA PEL N/K
ACGIH TLV: N/K
CARBON BLACK
CAS: 1333-86-4
RTECS: FF5800000
Fraction By Weight: 5%
OSHA PEL 3.5 MG/M3
ACGIH TLV: 3.5 MG/M3
3.36 LB/GAL (403 G/L) LESS
RTECS: 9999999VO
OSHA PEL N/K
ACGIH TLV: N/K
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ANIMAL STUDIES HAVE CLEARLY
DEMONSTRATED DOSE-RELATED ADVERSE EFTS ON THE CNS, HEMATOPOIETIC
TISS, BLOOD, KIDNEYS & LIVER ASSOC W/ADMIN OF ETHYLENE GLYCOL
MONOBUTYL ETHER (EGBE). (EXTRACTED FROM DHHS (NIOSH) PUB NO.
90-118) . INGEST:MAY CAUSE NAUS, RED BLOOD CELL DAM & POSS LIVER &
(EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ:KIDNEY DAM. CAN CAUSE GI IRRIT, NAUS &
VOM. ASPIR OF MATL INTO LUNGS MAY CAUSE CHEM PNEUMONITIS WHICH CAN
BE FATAL. INHAL:MAY CAUSE NOSE/THROAT IRRIT. HIGH CONC MAY CAUSE
ACUTE CNS DEPRESS CH ARACT BY HDCH, DIZZ, NAUS & CONFUSN. EYES:MAY
CAUSE SEV EYE IRRIT & CORNEAL DAM. SKIN:LIQ MATL MAY BE ABSORBED
(SUP DAT)
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
First Aid
First Aid:INGEST:DO NOT INDUCE VOM. GIVE 1 OR 2 GLASSES OF WATER TO
DILUTE (NEVER GIVE ANYTHING BY MOUTH TO AN UNCON PERS). CALL POIS
CTL CTR, HOSP EMER ROOM OR MD IMMED. INHAL:REMOVE TO FRESH AIR
IMMED. IF BRT HG HAS STOPPED, GIVE ARTF RESP. KEEP WARM/QUIET. GET
MED ATTN IMMED. EYES:FLUSH W/LGE AMTS OF WATER, LIFTING UPPER/LOWER
LIDS OCCASNLY. CONTINUE FOR AT LEAST 15 MINS. GET MED ATTN. SKIN:
(ING 10)
Fire Fighting
Flash Point Method:SCC
Flash Point:106F,41C
Lower Limits:SEE INGREDS
Upper Limits:SEE INGREDS
Extinguishing Media:USE NFPA CLASS B FIRE EXTINGS (CO2, ALL PURPOSE DRY
CHEM OR ALCOHOL FOAM) DESIGNED TO EXTING FLAMM LIQ FIRES. (SUP DAT)
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP
. WATER MAY BE INEFT, BUT MAY BE USED TO COOL EXPOSED CONTRS TO
PVNT PRESS BUILD-UP & POSS (SUP DAT)
Unusual Fire/Explosion Hazard:DURING EMER CNDTNS, OVEREXPOS TO DECOMP
PRODS MAY CAUSE HLTH HAZ. SYMPS MAY NOT BE IMMED APPARENT. OBTAIN
MED ATTN. KEEP CONTRS TIGHTLY CLSD. ISOLATE (SUP DAT)
Accidental Release
Spill Release Procedures:WEAR NIOSH/MSHA APPRVD RESPS, EYE, HAND & BODY
PROT APPROP FOR SIZE OF SPILL & EXPOS ENCOUNTERED. KEEP SPECTATORS
AWAY. ELIM ALL IGNIT SOURCES (FLAMES, HOT SURF & SOURCES OF ELEC,
STATIC OR FRICATIONA L SPARKS). DIKE & CONTAIN SPILL W/INERT(ING
14)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:DO NOT STORE >115F. STORE LGE QTYS IN
COMPLIANCE W/OSHA 29CFR1910.16. DO NOT TAKE INTERNALLY. CLOSE CONTR
AFTER EACH USE. AVOID SKIN CONTACT.
Other Precautions:EMPTY CONTRS MUST NOT BE WASHED & REUSED FOR ANY
PURPOSE. CONTRS SHOULD BE GROUNDED & BONDED TO THE RECEIVING CONTR.
DO NOT WELD, BRAZE OR CUT ON EMPTY CONTR. NEVER USE PRESS TO EMPTY.
DRUM IS NOT A P RESS VESSEL.
Exposure Controls
Respiratory Protection:PROPER SELECTION OF RESP PROT DEPENDS UPON MANY
FACTORS INCL DURATION & LEVEL OF EXPOS & CNDTNS OF USE. IN GEN
EXPOS TO ORG CHEMS SUCH AS THOSE CONTAINED IN PROD MAY NOT REQ USE
OF RESP PROT IF USED I N WELL VENTD AREAS. IN AREAS (ING 18)
Ventilation:PROVIDE GEN DILUTION & LOC EXHST VENT IN SUFFICIENT VOL &
PATTERN TO KEEP CONC OF HAZ INGREDS LISTED IN INGRED (ING 23)
Protective Gloves:SOLVENT IMPERMEABLE GLOVES.
Eye Protection:CHEMICAL SAFETY GOGGLES .
Other Protective Equipment:EYE WASH FACILITY & SAFETY SHOWER.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
EXTING MEDIA:POLYMER FOAM IS PREF FOR LGE FIRES. FIRE FIGHT
PROC:AUTO-IGNITION OR EXPLOS WHEN EXPOSED TO EXTREME HEAT. IF WATER
IS USED, FOG NOZZ ARE PREF. EXPLO HAZ:FROM HEAT, ELEC EQUIP, SPARKS
& FL AME. CLSD CONTRS MAY EXPLODE WHEN EXPOSED TO EXTREME HEAT.
EFTS OF OVEREXP:THRU SKIN IN HARMFUL AMTS. MAY (ING 7)
Chemical Properties
HCC:F4
Boiling Pt:B.P. Text:>212F,>100C
Vapor Pres:SEE INGRED
Vapor Density:HVR/AIR
Spec Gravity:1.1
Evaporation Rate & Reference:SLOWER THAN DIETHYL ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:48
Stability
Stability Indicator/Materials to Avoid:YES
STRONG ACIDS OR ALKALINE MATERIALS.
Stability Condition to Avoid:AVOID EXCESSIVE HEAT (>115F, >46C) &
SOURCES OF IGNITION.
Hazardous Decomposition Products:BURNING, INCLUDING WHEN HEATED BY
WELDING OR CUTTING, WILL PRDCE SMOKE, CARBON MONOXIDE & CARBON
DIOXIDE.
Disposal
Waste Disposal Methods:DISP I/A/W FED, STATE & LOC LAWS. INCIN ONLY IN
EPA PERMITTED FACILITY. DO NOT INCIN CLSD CONTRS. OBSERVE PRECS FOR
DISP OF FLAMM MATLS. CONTAMD ABSORB MAY BE DISPOSED IN A HAZ WASTE
LANDFILL. DISP ON LY I/A/W FED, STATE & LOC REGS. PROD, IF (ING 17)
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.